|
The experts at
Dominator say it is not a good idea to
weld tabs onto an aluminum radiator but to make some sort of bracket that uses a
clamp rather than just bolting tabs to the support.
|
  |
I TIG welded plates to the ends of 1" X 1" tubing that was
cut at a 45 degree angle. I sanded the weld smooth and attached the tabs I
had made for bolting to the radiator support |
|
  |
Using the press I bent the 1/8" plate to step it up over the
first pieces I made. The bottom of the radiator has 2 flanges that extend
the length of the radiator and fit snug over the 1/8" plate |
|
 |
This is the upper
clamp. This design is the way I was told to do it at work, I would have made
it differently |
|
